Trane Flash Codes. Trane Rtrm Board Led 2 Flash Code Flashing 4 times on the red light mainly notifies that the high limit switch has been tripped. Below is a table that outlines the diagnostic flash code meanings for the Trane XR80 furnace: Flash Pattern Meaning; Flashing Slow: Normal - no call for heat: Flashing Fast: Normal - call for heat: Continuous On: Replace control: Continuous Off: Check for power: 2 Flashes: System lockout (no flame) or reversed polarity:
Trane XE80 No Heat, Blowing Cold Air Intermittent DoItYourself from www.doityourself.com
Flashing 4 times on the red light mainly notifies that the high limit switch has been tripped. A system lockout usually occurs after multiple failed attempts to ignite or complete a heating cycle
Trane XE80 No Heat, Blowing Cold Air Intermittent DoItYourself
Fail Code: Possible Cause or Next Step: J6-6: J6-7: Pulsing: Heat: Gas heat (See ignition module for further fault codes): If any failure occurs such as loss of flame, limit switch trip, flame rollout etc Flashing Red LED - The sensor is not detecting proper temperature, indicating a possible faulty sensor or a wiring issue. (failure to ignite, no spark, low/ no gas pressure, etc.) 3 Flashes: Pressure switch problem detected
Why am I getting an 8 flash code on my economizer? Trane Commercial. There is no one-size-fits-all answer to this question, as the codes for a Trane furnace will vary depending on the model and year of your furnace To reset your furnace, locate the power switch or thermostat and turn it off for a few minutes.
Trane XR80 Blinking Red Light Furnace Troubleshooting. However, you can generally find the code information for your furnace. Slow Flash Rate Normal, call for heat (¾ second on, ¼ second off) 1 Flash : Loss of Communication 2 Flashes: System Lockout: Failed to detect or sustain a flame